Page 1 of 1

ZAS/LP throttle lever

PostPosted: Thu Jan 21, 2021 7:57 pm
by John Grandfield
Anyone have one they could give measurements from? Mine must have one from a ZA, it' stoo long, hits the steering wheel on one end and the dash on the other.

Re: ZAS/LP throttle lever

PostPosted: Tue Jan 26, 2021 6:21 pm
by G Brown
Lever same on gas? Three ZAS went scrap last week.

Re: ZAS/LP throttle lever

PostPosted: Wed Jan 27, 2021 9:18 am
by John Grandfield
there is a different part number for a standard LP than a standard. Don't know what the difference is, hoping someone would know, mine hits the dash on one end of travel and the steering wheel on the other. MM Del tells me his is just upside down on his LP but looks similar. I'm going to try that this morning

Re: ZAS/LP throttle lever

PostPosted: Wed Jan 27, 2021 9:49 am
by MMDEL
John I checked the difference is, the ZBS is a straight handle like all the other tractors and the ZBU, N, E is a bent handle.
MMDEL

Re: ZAS/LP throttle lever

PostPosted: Wed Jan 27, 2021 12:38 pm
by G Brown
ZAS uses a 10A344 and crosses to 10A2230. All same according to books

Re: ZAS/LP throttle lever

PostPosted: Thu Jan 28, 2021 10:01 am
by John Grandfield
GB, since both those numbers appeared in the same book in the description I never bothered to see if they changed to the same number. Del looked at his and told me to turn mine upside down, it works that way. Thanks for all the replies