The early 90's series F350's had an HCU (Hydraulic Control Unit) < managed by the ABS controller, the HCU is located under the drivers feet on the inside of the left frame rail.
the process of bleeding the brakes MUST include this unit (Spongy, and Eratic, brakes ??? you need to do this).
RR (passengers Rear), Drivers rear, the HCU, Passengers front, drivers front.
the only picture i can find on the internet.....
The early 90's series F350's had an HCU (Hydraulic Control Unit) < managed by the ABS controller, the HCU is located under the drivers feet on the inside of the left frame rail.
the process of bleeding the brakes MUST include this unit (Spongy, and Eratic, brakes ??? you need to do this).
RR (passengers Rear), Drivers rear, the HCU, Passengers front, drivers front.
the only picture i can find on the internet.....
https://imgur.com/gallery/FQM6VdKThe round "tube thing" points forward... see the bleed port ??? THERE is where.
USE A 2L POP BOTTLE WITH A CLEAR HOSE FROM THE BLEED PORT TO THE BOTTLE (USE THE CAP) AND MAKE A HOLE IN THE CAP TO HOLD THE TUBE IN A SMALL AMOUNT OF BRAKE FLUID IN THE BOTTLE keep the bottom of the tube submerged. do the bleed in the order indicated above.......
The round "tube thing" points forward... see the bleed port ??? THERE is where.
USE A 2L POP BOTTLE WITH A CLEAR HOSE FROM THE BLEED PORT TO THE BOTTLE (USE THE CAP) AND MAKE A HOLE IN THE CAP TO HOLD THE TUBE IN A SMALL AMOUNT OF BRAKE FLUID IN THE BOTTLE keep the bottom of the tube submerged. do the bleed in the order indicated above.......